At present, a lot of people working in some special environment, or often encounter some emergency things, which in many places there will be some special cases, what about the simple relief tent structures, how to do, today we analysis also love for you, hope to be able to help you.
Take out general stem eight root and has good bonding fixed the three groups of end of the wire rope tee, in stone herringbone and connected into three groups.
Take general tee, in 4 root and end of stem of four-way framework.
The whole cotton tank set in three groups on the shaft bracket, adjust the position make cotton bladder tent on the shaft strut bar in the middle.
Outer tent set in three groups of a-frame cotton outside the tank, and adjust the position.
Stud 6 rods respectively inserted into the tee and four-way, tent with six people together to set up, and have been put to rod head member joined up.
Gable side wall and cotton cotton bladder bladder with nylon thread gluing adhesive is good, and adjust the position.
Will be a single tent body of the vertical rod parts after the strapping tape through the cotton inner circle of copper covered strapping on each post.
Each part banding belt fasten, nylon zippers buckle, and adjust the tent position, connected to the framework of the bar.
Side walls and gable shakedown tent bladder by nylon fastening adhesion.
The corresponding location on the ground into the triangle pile, fixed rope, adjust the tightness, and rubber pile head set on the triangular pile end.
Tents, ridging buried around the tent.
Above, is about the building of disaster relief tents, don't know what we have set up the way and good advice or opinion, welcome to leave a message, the small make up think everyone can learn, more it is life's little common sense, facilitate everybody encountered later in the life good is emergency response to treatment.
On a story: a: how shall we build the construction tent next article: next up: construction tents in the choice of the points for attention